Check your Air Data - Setup and Practical Examples for the Flight Data Compatibility Check

Christian Raab Research Scientist, DLR (German Aerospace Center), Institute of Flight Systems (Germany)

Abstract

Accurate information about aircraft speed, altitude, and aerodynamic flow angles is essential for evaluating aircraft performance and handling qualities. These quantities are determined from air data measurements taken by sensors normally located near the aircraft cockpit. Since these sensors are affected by the distorted flow field around the fuselage, a correction must be applied. Before the first flight, a set of calibration parameters is usually determined from wind tunnel experiments or CFD calculations.

However, the Data Compatibility Check (DCC) method allows a more accurate air data sensor calibration during the certification flight test. This method reconstructs air data quantities from inertial acceleration, angular rate measurements and the flight path. By comparing the reconstructed quantities with the measured ones, the structure and parameters of air data sensor models can be identified. In this paper an introduction to the data compatibility check method and the setup used in a flight test for system identification is given. The DCC is applied on data gathered from a test campaign with the new DLR research aircraft Dassault Falcon 2000LX ISTAR.

Use cases for the calibration of the nose boom airflow vanes and the correction of sensors during large sideslip maneuvers will be presented in this paper.